In-grade Lighting Fixtures Are Rated for Wet Indoor and Outdoor Applications

Vista Architectural Lighting has added three new models to its line of 1180 Series COB (Chip-On-Board) LED In-Grade lighting fixtures: the 1180 drive-over in-grade, 1181 marker light and 1182 in-grade—all with a low-profile, 4-inch fixture height.

With a drive-over rating of 7,000 pounds and IP68 certification, the 1180 drive-over in-grade is designed for direct burial in poured concrete, making it suitable for hotel or casino driveways to create easily visible traffic lanes.

The 1182 in-grade includes a patented, magnetic hot-aiming system. This system utilizes a Vista-supplied magnetic tool that’s externally applied to the fixture’s lens and then mated with a magnet affixed to the pre-installed tilt optics of 5, 10 or 15 degrees or a linear spread. With the wand and the magnet mated, the internal tilt optics can be rotated up to 360° with no need to open the fixture, saving time and further enhancing lighting customization.

With a drive-over rating of 7,000 pounds and IP68 certification, the 1180 drive-over in-grade is designed for direct burial in poured concrete, making it suitable for hotel or casino driveways to create easily visible traffic lanes. The 1180 is also useful indoors to mark walkways and pathways.

The 1181 marker light pushes light to the side, making it ideal for illuminating appropriate travel directions on pathways, sidewalks and driveways, while the 1182 circular, in-grade fixture provides attractive uplighting for architectural features and signage. The 1182 is available with or without a trim ring for further customization. Both models are low profile, with a 4- to 5-inch fixture height, making them easier to install and design around in tight areas. Their unitized housing offers the high-load strength required for outdoor use. While the 1181 marker is not intended for drive-over applications, the 1182 has a drive-over rating of 10,000 pounds, making it extremely versatile.

The 1180, 1181 and 1182 are rated for wet indoor and outdoor applications. All utilize integrated COB LED technology—up to 450 delivered lumens for the 1180 and 1181 and up to 1,300 delivered lumens for the 1182—in color temperatures ranging from 2700K to 5000K. The 1182 offers different flood variations that allow the optics to go from a very narrow spot to a wide flood. A piston gasket on the perimeter of the factory-sealed lamping module creates a water-tight seal to the Rough-In-Section (RIS), making these non-flow-through luminaires ideal for indoor applications as well as outdoor installations where drainage is not practical.

Be the first to comment on "In-grade Lighting Fixtures Are Rated for Wet Indoor and Outdoor Applications"

Leave a comment

Your email address will not be published.


*


%d bloggers like this: