Coat Small Roof Areas while Minimizing Material Waste

BASF discovered the Sulzer MIXPAC MixCoat system for small and touchup applications in roofing.

BASF discovered the Sulzer MIXPAC MixCoat system for small and touchup applications in roofing.

Realizing there was no easy and cost-effective way to apply rapid-cure sealants for small applications with minimal setup time and little material waste, BASF discovered the Sulzer MIXPAC MixCoat system for small and touchup applications in roofing. Only an air compressor and a MixCoat spray system are needed. Preparation time can be reduced to 15 minutes. With MixCoat’s use of cartridges, very small areas can be coated while minimizing coating waste, and partially used cartridges can be recapped and reused for the next project. The prefilled cartridges also protect the applicator from direct contact with unmixed material, adding another layer of safety. In addition, the MixCoat system uses low pressure compressed air, 7 bar (100 psi).

Be the first to comment on "Coat Small Roof Areas while Minimizing Material Waste"

Leave a comment

Your email address will not be published.


*


%d bloggers like this: